Hampton Bay 26612 Installation Guide download pdf (Page 8)

6.

WHEN USING THE STANDARD BALL/DOWNROD

MOUNTING, THE TAB IN THE RING AT THE BOT-

TOM OF THE MOUNTING PLATE MUST REST IN

THE GROOVE OF THE HANGER BALL. FAILURE

TO PROPERLY SEAT THE TAB IN THE GROOVE

COULD CAUSE DAMAGE TO WIRING.

Installing Fan to

the Outlet Box

WHEN MOUNTING THE FAN ON A SLOPED

CEILING, THE STANDARD BALL/DOWNROD

MOUNTING METHOD MUST BE USED. MAKE

SURE THE MOUNTING BRACKET SLOTS ARE

ON THE LOWER SIDE BY SLIDING THE MOUNT-

ING BRACKET FROM THE TOP DOWN.

1. Pass the 120-volt supply wires through the

center hole in the ceiling mounting bracket

as shown in Figure 7.

2. Install the ceiling mounting plate on the out-

let box by sliding the mounting plate over

the two screws provided with the outlet

box. When using close-to-ceiling mount-

ing, it is important that the mounting plate

be level. If necessary, use leveling washers

(not included) between the mounting plate

and the outlet box. Note that the at side of

the mounting plate is toward the outlet box

(Figure 7).

3. Securely tighten the two mounting screws.

4. Carefully lift the assembly up to the ceil-

ing mounting plate. If using Close-to-

Ceiling mounting, hang the fan on the

hook provided by utilizing one of the

holes at the outer rim of the ceiling canopy

(Figure 12). If using standard mounting, seat

the hanger ball in the mounting plate socket.

Make sure the tab on the mounting bracket

socket is properly seated in the groove in the

hanger ball (Figure 12).

Close-to-Ceiling

Mounting

Standard

Mounting

Figure 12

THE HOOK AS SHOWN IN FIGURE 12 IS ONLY

TO BALANCE FAN WHILE ATTACHING WIRING.

FAILURE TO HANG AS SHOWN IN FIGURE 12

MAY RESULT IN HOOK BREAKING, CAUSING

THE FAN TO FALL. HOOK MUST PASS FROM

INSIDE TO OUTSIDE OF CANOPY.

Making the Electrical

Connections

REMEMBER to disconnect the power. If

you feel you do not have enough electrical

wiring knowledge or experience, have your fan

installed by a licensed electrician.

Follow the steps below to connect the fan

to your household wiring. Use the wire

connecting nuts supplied with your fan

and supplied with remote control. Se

-

cure the connectors with electrical tape.

Make sure there are no loose strands or

connections (Figure 13).

1. Connect the ground conductor of the 120v

supply (this may be a bare wire or a wire

with green colored insulation) to the green

ground lead(s) of the fan (Figure 13).

2. Connect the fan motor white wire to

the receiver white wire using a wire nut

(Figure 13).

3. Connect the fan motor black wire to

the receiver black wire using a wire nut

(Figure 13).

4. Connect the fan motor blue wire to the

receiver blue wire using a wire nut

(Figure 13).

5. Connect the receiver red wire to the sup-

ply black (hot) wire using a wire nut

(Figure 13).

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 32 33

Comments to this Manuals

No comments