Hampton Bay 26612 Installation Guide download pdf (Page 12)

Mounting

Screw(3)

Plastic Plug

Figure 19

Figure 18

Blade Balancing

All blades are grouped by weight. Because nat-

ural woods vary in density, the fan may wobble

even though the blades are weight matched. The

following procedure should correct most fan

wobble. Check after each step.

1. Check that all blade and blade bracket

screws are secure.

2. Most fan wobble problems are caused when

blade levels are unequal. Check this level by

selecting a point on the ceiling above the tip

of one of the blades. Measure from a point

on the center of each blade to the point on the

ceiling. Measure this distance as shown in

Figure 19. Rotate the fan until the next blade

is positioned for measurement. Repeat for

each blade. Measurement deviations should

within 1/8”. Run the fan for 10 minutes.

3. If the fan continues to wobble please contact

Customer Service and a balacing kit will be

sent to you at no charge.

Fan Without Light Kit

1. In order to use the fan without the light kit,

remove the switch cup cover from the top

of the light kit tter by removing the cen-

ter hex nut inside the switch cup cover, and

then thread the switch cup cover off of the

threaded nipple on the top of the light kit

tter.

2. Press the plastic plug (provided) into the

center hole of the switch cup cover.

3. Remove the three screws from the switch

cup cover of the light tter.

4. Align the three screw holes in the switch cup

cover with the three holes in the switch cup.

5. Position the switch cup cover onto the

switch cup and install the three screws that

were removed in step 3. Tighten the three

screws (Figure 18).

10.

TO AVOID POSSIBLE FIRE OR SHOCK, THE

CONNECTORS SHOULD BE REMOVED UNLESS

A LIGHT KIT WILL BE IMMEDIATELY INSTALLED

AND THAT POWER SHOULD BE TURNED OFF

PRIOR TO CONNECTOR REMOVAL LIGHT KIT

INSTALLATION.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 32 33

Comments to this Manuals

No comments