Hampton Bay 26612 Installation Guide download pdf (Page 10)

8.

CLOSE-TO-CEILING MOUNTING

1. Carefully unhook the fan from the mount-

ing plate and align the locking slots of the

ceiling canopy with the two screws in the

mounting plate. Push up to engage the slots

and turn clockwise to lock in place. Imme-

diately tighten the two mounting screws

rmly.

2. Install the remaining two mounting screws

into the holes in the canopy and tighten

rmly.

3. Install the decorative canopy ring by align-

ing the ring’s slots with the screws in the

canopy. Rotate the ring clockwise to lock

in place.

4. You may now proceed to attaching the fan

blades.

LOCKING SLOTS OF CEILING CANOPY ARE

PROVIDED ONLY AS AN AID TO MOUNTING.

DO NOT LEAVE FAN ASSEMBLY UNATTENDED

UNTIL ALL FOUR CANOPY SCREWS ARE EN-

GAGED AND FIRMLY TIGHTENED.

Attaching the

Fan Blades

NOTE: Your fan blade are reversible. Select

the blade side nish which best accentuates

your decor.

1. Attach blade to blade bracket using the

screws as shown in gure 14. Please note that

the rubber washers are pre-attached to the

blade bracket. Start a screw into the bracket.

Repeat for the two remaining screws.

2. Tighten each screw securely.

3. Fasten the blade assembly to the motor by

inserting the alignment post into the slot on

the bottom of the motor and tightening the

blade bracket screws. Please note that the

blade bracket screws are pre-installed into

the blade bracket (Figure 15).

4. Repeat steps 1-3 for the remaining blades.

Blade /Blade Arm

Assembly

Screws

Slot

Alignment Post

Blade Arm

Blade

Rubber Washers

Screws

Figure 14

Figure 15

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 32 33

Comments to this Manuals

No comments