Item #593-560USE AND CARE GUIDEQuestions, problems, missing parts? Before returning to the store, call Hampton Bay Custom
5Making the electricalconnectionsOOPPRRQQSSUUTTBBMMIf you feel you do not have enough electrical wiring knowledge or experience, have your fan install
BDDDDACBDDC6Installing the canopy7Attaching the canopy bottom cover11 HAMPTONBAY.COMPlease contact 1-877-527-0313 for further assistance.□ Removin
10Fastening the blade assemblies to the motor9Attaching the blades to the blade armsAAHG8Removing the rubberpacking mountsFGHBFWWHHXX12□ The fan
11Attaching the switch housingto the mounting ring12IIIYY□ Remove one of the three switch housing mounting screws (II) from the mounting ring (YY)
□ Install the three 40W candelabra bulbs (KK) (included).□ Pass the two pull chains (LL) on the switch housing (I) through the chain holders
PULL CHAIN OPERATING INSTRUCTIONSPULL CHAIN OPERATING INSTRUCTIONSAttach the two pull chains and fobs (LL) to the pull chains located on the switch ho
Care and CleaningTroubleshooting DoDoProblemProblemSolutionSolution□ Use water when cleaning. Water could damage the motor, or the wood, or possib
ProblemProblemSolutionSolution□ Check that all blade and blade arm screws are secure.□ Most fan wobble problems are caused when blade levels
AGHIJKAAGGHHIIJJKKLLBBDDEEFFCCBCDEF PartPartABCDEFGHIJKDescriptionDescriptionMounting bracketCanopyCanopy bottom coverHanger ball/downrod assemblyCoup
Questions, problems, missing parts? Before returning to the store, callHampton Bay Customer Service8 a.m. - 6 p.m., EST, Monda
Table of Contents ...Safety Information ...
Safety Information 1. To reduce the risk of electric shock, ensure electricity has been turned off at the circuit breaker or fuse box before begi
SPECIFICATIONSSPECIFICATIONSTOOLS REQUIREDTOOLS REQUIREDPhillips screwdriverElectrical tapeWire stripperFlat blade screwdriverStep ladderNOTE: These a
Pre-Installation (continued)HARDWARE INCLUDEDHARDWARE INCLUDEDAABBCCDDEEFFGGHHIIJJKKLLBlade attachment screw and rubber washer Plastic wire nutBalance
PartPartGHIJKDescriptionDescriptionBladeBlade armSwitch housingLight kitGlass shadeABCDEIJKFGHPartPartABCDEFQuantityQuantity111111QuantityQuantity551
To hang your fan where there is an existing fixture but no ceiling joist, you may need an installation hanger bar (NN) (not included) as shown above.
1Preparing the motor□ Remove the clevis pin (EE) and cotter pin (FF), and loosen the two collar setscrews (GG) from the fan motor assembly (F) co
3Attaching the mounting bracket to the electrical boxHanging the fan from the mounting bracket□ Pass the 120-volt supply wires through the center
Comments to this Manuals