Hampton Bay 26612 Installation Guide download pdf (Page 7)

“Close-to-Ceiling” Mounting

1. Remove the canopy ring from the canopy

by turning the ring to the right until it

unlocks (Figure 5).

2. Remove the mounting plate from the cano-

py by loosening the four screws on the top

of the canopy. Remove the two non-slotted

screws and loosen the slotted screws. This

will enable you to remove the mounting

plate (Figure 6).

3. Remove the decorative canopy bottom cov-

er from the canopy by depressing the three

studs (Figure 9).

4. Remove three of the six screws and lock-

washers (every other one) securing the mo-

tor collar to the top of the fan motor housing

(Figure 10).

5. Place the rubber gasket over the remain-

ing three screws, route the wires exiting

the top of the fan motor through the canopy

ring (make sure the slot openings are on

top), then proceed to place the ceiling can-

opy over the collar at the top of the motor

(Figure 11).

5.

4. Loosen, but do not remove, the set

screw on the collar on the top of the

motor housing.

5. Align the holes at the bottom of the

downrod with the holes in the collar

on top of the motor housing (Figure 7).

Carefully insert the hanger pin through

the holes in the collar and downrod. Be

careful not to jam the hanger pin against

the wiring inside the downrod. Insert the

locking pin through the hole near the

end of the hanger pin until it snaps into its

locked position, as noted in the circle inset

of Figure 7.

6. Re-tighten the set screws on the collar on top

of the motor housing (Figure 8).

7. Proceed to “Installing the Fan” section.

FAILURE TO PROPERLY INSTALL SET SCREWS

IN STEP 7 COULD RESULT IN FAN LOOSENING

AND POSSIBLY FALLING.

FAILURE TO PROPERLY INSTALL THE LOCK-

ING PIN AS NOTED IN STEP 5 COULD RESULT

IN FAN LOOSENING AND POSSIBLY FALLING.

Figure 9

Canopy

Bottom

Cover

Figure 10

Figure 11

Motor

Collar

Screw and

Lockwasher

(3 of 6 Screws)

Collar

Screw and

Lockwashe

r

(3 Screws)

Ceiling

Canopy

Canopy

Ring

Rubber

Gasket

6. Align the mounting holes with the holes

in the motor and fasten, using the three

screws and lock-washers removed in step 4

(Figure 11).

7. Tighten the mounting screws securely.

Figure 8

Tighten

Set

Screws

1 2 3 4 5 6 7 8 9 10 11 12 ... 32 33

Comments to this Manuals

No comments