Hampton Bay 24816-021 Instruction Manual download pdf (Page 12)

□ This unit is equipped with a wattage limiting device. Lamping in excess of 190 watts will disable your

ceiling fan's light kit. To reset your light kit you must turn the power off and relamp, keeping the

wattage under 190 watts. Restore power to your ceiling fan and continue normal operation.

□ Do not connect the fan with wall mounted variable speed control(s).

□ Check to make sure the dip switches from the remote control and receiver are set to the same

frequency.

□ Check that all blade and blade arm screws are secure.

□ Most fan wobble problems are caused when blade levels are unequal. Check this level by selecting a

point on the ceiling above the tip of one of the blades. Measure from a point on the center of each blade

to the point on the ceiling. Rotate the fan until the next blade is positioned for measurement. Repeat for

each blade. Measurements deviation should be within 1/8 in. Run the fan for 10 minutes.

□ Use the enclosed blade balancing kit if the blade wobble is still noticeable.

The lights turn off and will

not come back on.

The fan wobbles.

The remote control is

not working.

Troubleshooting

Problem Solution

□ Check the main and branch circuit fuses or breakers.

□ Check the line wire connections to the fan and switch wire connections in the switch housing.

□ Check to make sure the dip switches from the remote control and receiver are set to the same

frequency.

□ Make sure all motor housing screws are snug.

□ Make sure the screws that attach the fan blade arm to the motor hub are tight.

□ Make sure wire nut connections are not rattling against each other or the interior wall of the switch

housing.

□ Allow a 24-hour "breaking-in" period. Most noises associated with a new fan disappear during this

time.

□ If using the ceiling light kit, make sure the metal nut securing the glassware is tight. Check that the light

bulb is also secure.

□ Make sure there is a short distance from the ceiling to the canopy. It should not touch the ceiling.

□ Make sure your ceiling box is secure and rubber isolator pads are used between the mounting bracket

and outlet box.

The fan will not start.

The fan sounds noisy.

WARNING: Ensure the power is off at the electrical panel

box before you attempt any repairs. Refer to step 8 “Making

the Electrical Connections” on page 11.

1 2 ... 7 8 9 10 11 12 13 14

No comments

Hampton Bay 24816-021 Instruction Manual Page 12