Hampton Bay 14035 Installation Guide download pdf (Page 7)

Receiver

Hanger bracket

Figure 11

Figure 12

WARNING: To avoid possible electrical

shock be sure electricity is turned off at the

main fuse or breaker box before wiring.

NOTE: The Hand Held Remote or Wall

Control units included with your ceiling fan

are equipped with 16 code combinations to

prevent possible interference from or to

other remote units. The dip switches on your

Receiver and Transmitter units have been

preset at the factory, please re-check to make

sure the switches on both units are set to the

same positions. The frequency settings

s h o u l d b e c h a n g e d o n l y i n c a s e o f

interference or if a second or more remote

controlled ceiling fans are installed in the

same structure. Any code combination will

operate the ceiling fan and light as long as

the Receiver and Transmitter units are set to

the same codes (Fig. 11)

Step 1. Insert Receiver into Hanger Bracket

with the flat side of the Receiver facing the

ceiling. (Fig. 12)

St ep 2 . Motor t o Receiver El ec trical

Connections: Connect the WHITE wire from

the fan to the WHITE wire marked "TO

MOTOR N" from the Receiver. Connect the

BLACK wire from the fan to the BLACK

Wire

marked "TO MOTOR L" from the Receiver.

Connect the BLUE wire from the fan to the

BLUE wire marked "For Light" from the

Receiver. NOTE: If your ceiling fan features

an UP Light: Connect the ORANGE wire

from the fan to the ORANGE wire marked

"For Up Light" from the Receiver. Otherwise

disregard this step and proceed to secure all

wire connections with the plastic wire nuts

provided. (Fig. 13 )

Step 3. Receiver to House Supply Wires

Electrical Connections: Connect the WHITE

wire (Neutral) from the outlet box to the

WHITE wire marked "AC in N" from the

receiver. Connect the BLACK wire (Hot)

from the outlet box to the BLACK wire

marked "AC in L" from the receiver. Secure

all wire connections with the plastic wire

nuts provided. (Fig. 13

Step 4. If your outlet box has a GROUND

wire (Green or Bare Copper) connect this

wire to the Hanger Ball and Hanger Bracket

Ground wires. If your outlet box does not

have a Ground Wire, then connect the

Hanger Ball and Hanger Bracket Ground

Wires together. Secure wire connection with

the plastic wire nut provided. (Fig. 13 )

After all connectors are made, check to make

sure there are no loose strands. As an

additional precaution we suggest to secure

the plastic wire connectors to the wires with

electrical tape.

Note: Fan must be installed at a maximum

distance of 40 feet from the transmitting unit

for proper signal transmission between the

transmitting unit and the fan's receiving

unit.

ON

5. Electrical Connections

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments