Hampton Bay 14035 Installation Guide download pdf (Page 6)

REMEMBER to turn off the power.

Follow the steps below to hang your fan

properly:

Step 1. Secure the hanger bracket to the

ceiling outlet box using screws included

wi th you r outl et box, loc k w ash ers

included with the fan. (Fig.5)

Step 2. Loosen the two set screws and

remove the hitch pin and lock pin in the top

coupling of the motor assembly. (Fig.6)

Step 3. Remove hanger ball from downrod

a s s e m b l y b y l o o s e n i n g s e t s c r e w,

removing the cross pin, and sliding ball off

rod. (Fig.7)

Step 4. Carefully feed fan wires up

through the downrod. (Fig. 8) Thread the

rod into the coupling. Next line up holes

and replace lock pin and hitch pin. Tighten

set screws.

Step 5. Slip coupling cover, canopy cover

a n d c a n o p y o n t o d o w n r o d . ( F i g . 9 )

Carefully reinstall hanger ball onto rod

being sure that cross pin is in correct

position, set screws are tighten and wires

are not twisted.

Step 6. Now lift motor assembly into

position and place hanger ball into hanger

bracket. Rotate until the check groove has

dropped into the registration slot and seats

firmly. (Fig. 10) Rod should not rotate if

this is done correctly.

Outlet box

Hanger bracket

Cross pin

Hanger

ball

Downrod

Supply

wires

Figure 5

Figure 7

Figure 8

Figure 6

Figure 9

Figure 10

Registration

slot

Downrod

Coupling cover

Canopy

Canopy cover

Set screws

Hitch pin

Lock pin

Hitch

Lock

Set

screws

Hanger ball

Hanging the Fan 4.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments

Hampton Bay 14035 Installation Guide Page 6

Comments to this Manuals

Related products and manuals for Household fans Hampton Bay 14035