Baxter II52 in Ceiling FanOwner’s Manual Baxter IIVentilador de Techo de 1,32 mManual del Propietario 323-627
7WARNINGMAKE SURE THE TAB ON THE MOUNTING BRACKET PROPERLY SITS IN THE GROOVE IN THE HANGER BALL BEFORE ATTACHING THE CANOPY TO THE BRACKET BY TURNING
8Figure 13WARNINGTO REDUCE THE RISK OF PERSONAL INJURY, DO NOT BEND THE BLADE ARMS WHILE INSTALLING, BALANCING THE BLADES, OR CLEANING THE FAN. DO NO
9Blade BalancingCheck that all blade and blade bracket screws are secure.Most fan wobble problems are caused when blade levels are unequal. Check this
10Installing the Light Kit1.2.3.4.5.6.CAUTIONBEFORE STARTING INSTALLATION, DISCONNECT THE POWER BY TURNING OFF THE CIRCUIT BREAKER OR REMOVING THE FUS
111.2.3.4.CAUTIONBEFORE STARTING INSTALLATION, DISCONNECT THE POWER BY TURNING OFF THE CIRCUIT BREAKER OR REMOVING THE FUSE AT FUSE BOX. TURNING POWER
12Operating Your FanTurn on the power and check the operation of your fan. There are two pull chains available in your fan:1. 3-speed pull chain- it c
13Because of the fan's natural movement, some connections may become loose. Check the support connections, brackets, and blade attachments twice
14SpecificationsFAN SIZE SPEED VOLTS AMPS WATTS RPM CFM N.W. G.W. C.F.52” 1209.23 kgs(20.31 lbs)2.06'LOWMED.HIGH0.210.370.52102962541001471602312
15The Hampton Bay warrants the fan motor to be free from defects in workmanship and material present at time of shipment from the factory for a period
Baxter II by Hampton Bay®
52” Baxter IICeiling Fan by Hampton BayDate PurchasedStore PurchasedModel No.Serial No.Vendor No.UPCThank you for purchasing our ceiling fan. This pro
Safety Rules - Read and Save These InstructionsTo reduce the risk of electric shock, insure electricity has been turned off at the circuit breaker or
2Unpacking Your FanUnpack your fan and check the contents. You should have the following items:ABC123456789101112Set of blades (5)Canopy assemblyBall
3Installing Your FanFigures 1~3 are examples of different ways to mount the outlet box.If there isn't an existing UL listed mounting box, then re
4REMEMBER to turn off the power. Follow the steps below to hang your fan properly.Hanging the FanWARNINGFAILURE TO PROPERLY INSTALL COTTER PIN AS NOT
5Installing Fan to the Electrical BoxWARNINGTHE TAB IN THE RING MUST REST IN THE GROOVE OF THE HANGER BALL AS FIGURE 8. FAILURE TO PROPERLY SEAT THE T
6Making the Electrical ConnectionsWARNINGCHECK TO SEE THAT ALL CONNECTIONS ARE TIGHT, INCLUDING GROUND, AND THAT NO BARE WIRE IS VISIBLE AT THE WIRE N
Comments to this Manuals