Hampton Bay AL685-ORB Use and Care Manual

Devereaux II52 in Ceiling FanOwner’s Manual Devereaux IIVentilador de Techo de 1,32 mManual del Propietario 321-977

7SUPPLY CIRCUITFigure 11WHITEWHITEBLACKBLACKBLUEGroundConductorOutlet BoxGreen GroundLeadGREENGround toDownrodBLACKBLACKBLUEWHITEWHITEWARNINGMAKE SURE

8Figure 14WARNINGTO REDUCE THE RISK OF PERSONAL INJURY, DO NOT BEND THE BLADE ARMS WHILE INSTALLING, BALANCING THE BLADES, OR CLEANING THE FAN. DO NO

9Blade BalancingCheck that all blade and blade bracket screws are secure.Most fan wobble problems are caused when blade levels are unequal. Check this

10Installing the Light Kit1.2.3.4.5.CAUTIONBEFORE STARTING INSTALLATION, DISCONNECT THE POWER BY TURNING OFF THE CIRCUIT BREAKER OR REMOVING THE FUSE

1111"HI, MED, LOW" buttons:These three buttons are used to set the fan speed as follows:LOW=Low speed, MED= Medium speedHI=High speed"O

12Speed settings for warm or cool weather depend on factors such as the room size, ceiling height, number of fans, etc.The reverse switch is located o

13WARNINGMAKE SURE THE POWER IS OFF AT THE ELECTRICAL PANEL BOX BEFORE YOU ATTEMPY ANY REPAIRS. REFER TO THE SECTION, “MAKING ELECTRICAL CONNECTIONS”.

14SpecificationsFAN SIZE SPEED VOLTS AMPS WATTS RPM CFM N.W. G.W. C.F.52” 12011.25 kgs(24.75 lbs)12.75 kgs(28.05 lbs)2.58’LOWMED.HIGH0.340.490.5612346

15The Hampton Bay warrants the fan motor to be free from defects in workmanship and material present at time of shipment from the factory for a period

Devereaux II by Hampton Bay®

52” Devereaux IICeiling Fan by Hampton BayDate PurchasedStore PurchasedModel No.Serial No.Vendor No.UPCThank you for purchasing our ceiling fan. This

Safety Rules - Read and Save These InstructionsTo reduce the risk of electric shock, insure electricity has been turned off at the circuit breaker or

2Unpacking Your FanUnpack your fan and check the contents. You should have the following items:ABC12345678591012111413Set of blades (5)Canopy assembl

3Installing Your FanFigures 1~3 are examples of different ways to mount the outlet box.If there isn't an existing UL listed mounting box, then re

4REMEMBER to turn off the power. Follow the steps below to hang your fan properly.Hanging the FanWARNINGFAILURE TO PROPERLY INSTALL COTTER PIN AS NOT

5Installing Fan to the Electrical BoxWARNINGTHE TAB IN THE RING MUST REST IN THE GROOVE OF THE HANGER BALL AS FIGURE 8. FAILURE TO PROPERLY SEAT THE T

6Making the Electrical Connections(Figure 11) Motor to receiver electrical connections: Connect the black wire from the fan to black wire marked "