Hampton Bay 36945 Instruction Manual download pdf (Page 9)

7.

Figure 11

Figure 12

TO REDUCE THE RISK OF PERSONAL INJURY,

DO NOT BEND THE BLADE HOLDERS WHILE

INSTALLING, BALANCING THE BLADES, OR

CLEANING THE FAN. DO NOT INSERT FOREIGN

OBJECTS BETWEEN ROTATING BLADES.

Attaching the Light Kit

& Glass Bowl

CAUTION - To reduce the risk of electrical

shock, disconnect the electrical supply circuit

to the fan before installing the light xture.

Loosen the three serrated head screws on 1.

the switch cup cover of the light kit tter

(Figure 12).

Connect the wires from the light kit tter 2.

to the wires from the switch cup of the fan

motor assembly by connecting the molded

adaptor plugs together (blue to black, white

to white). Carefully tuck all wires and splic-

es into the switch cup.

Align the three serrated head screws on the 3.

switch cup cover of the light kit tter with

the three key slots in the switch cup. Make

sure the notch in the switch cup cover of the

light kit tter clears the reversing switch in

the switch cup. Position the light kit tter

on the switch cup and turn it clockwise un-

til it locks. Tighten the three serrated head

screws that were loosened in step 1 to se-

cure the light kit tter (Figure 12).

Remove the rubber washer, hex nut, bottom 4.

cover and the nial from the light kit tter

(Figure 13).

With power off, install two 60 watt (maxi-5.

mum) candelabra base bulbs (included) into

the light kit tter sockets.

in Figure 11. Rotate the fan until the next

blade is positioned for measurement. Repeat

for each blade. Measurement deviations

should be within 1/8”. Run the fan for 10

minutes.

Use the enclosed Bladed Balancing Kit if 3.

the blade wobble is still noticeable.

Position the glass bowl over the threaded 6.

nipple and pass the fan switch chain through

the side hole in the glass bowl.

Re-install the rubber washer and hex nut 7.

to the threaded nipple of the light kit t-

ter to secure the glass bowl properly.

DO NOT OVER TIGHTEN THE HEX

NUT, OVERTIGHTENING THE HEX

NUT MAY CAUSE THE GLASS TO

BREAK.

Re-install the bottom cover and nial and 8.

nger tighten the nial.

CAUTION - Be sure that the fan switch chain

does not make contact with the light bulbs.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments