Hampton Bay 36945 Instruction Manual download pdf (Page 8)

6.

Finishing the Fan

Installation

Remove the two screws on two diagonal 1.

sides from the top of the mounting plate and

loosen the other two screws (Figure 8).

Align the two key slots on the top of the 2.

motor housing with the two screws on the

mounting plate, push the motor housing up

and turn it clockwise to lock in plate, tighten

the two screws.

Install the two screws that were removed 3.

in step 1 into the remaining two holes and

tighten rmly four screws.

Attaching the

Fan Blades

NOTE: Your fan blade are reversible. Select

the blade side nish which best accentuates

your decor.

Attach blade to blade bracket using the 1.

screws supplied (Figure 9). Please note that

the rubber washers are pre-attached to the

blade bracket. Start a screw into the bracket.

Repeat for the two remaining screws.

Tighten each screw securely.2.

Fasten the blade assembly to the motor by 3.

inserting the alignment posts into the slot

on the bottom of the motor and tightening

the motor screws. Please note that the mo-

tor screws are pre-attached into the blade

brackets (Figure 10).

Repeat steps 1-3 for the remaining blades.4.

Blade Balancing

All blades are grouped by weight. Because nat-

ural woods vary in density, the fan may wobble

even though the blades are weight matched.

The following procedure should correct most

fan wobble. Check after each step.

Check that all blade screws are secure.1.

Most fan wobble problems are caused when 2.

blade levels are unequal. Check this level by

selecting a point on the ceiling above the tip

of one of the blades. Measure from a point

on the center of each blade to the point on

the ceiling. Measure this distance as shown

Figure 9

Figure 10

Figure 8

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments