Hampton Bay 14938 Instruction Manual download pdf (Page 13)

10

Remove the 1 of 3 screws from the swith

housing mounting plate and loosen the other 2

screws. (Do not remove)

While holding the light plate under your fan,

connect the white wire connectors from the

light plate and switch housing, follow the same

procedure with the black wire connectors. (Fig.

19)

Carefully push all wires back into the switch

housing. Place the key holes on the light plate

over the 2 screws previously loosened from the

switch housing mounting plate, turn the light

kit assembly until it locks in place at the

narrow section of the key holes. Secure by

tightening the 2 screws previously loosened

and the one previously removed. (Fig. 19)

Install 1 x 13 watts compact fluorescent bulb

(included) into the light sockets. NOTE: CFL

bulbs are NOT dimmable.

Raise glass shade up against light plate and

secure it to fan by twisting glass clockwise

until snug. Do not overtighten. (Fig. 20)

1.

2.

3.

4.

5.

Loosen the 4 screws from the edge of light

plate. (Do not remove) Place the key holes on

the glass frame over the 4 screws previously

loosened from the light plate, turn the glass

frame until it locks in place at the narrow

section of the key holes. Secure by tightening

the 4 screws. (Fig. 20)

Restore power and your light kit is ready for

operation.

6.

7.

CAUTION

BEFORE STARTING INSTALLATION, DISCON-

NECT THE POWER BY TURNING OFF THE

CIRCUIT BREAKER OR REMOVING THE FUSE

AT FUSE BOX. TURNING POWER OFF USING

THE FAN SWITCH IS NOT SUFFICIENT TO

PREVENT ELECTRIC SHOCK.

Screws

Light Plate

Wire Connectors

Installing the Light Kit

Switch Housing

Mounting Plate

Figure 19

NOTE

LIGHT BULBS HAVE NO WARRANTY; CAN BE

PURCHASED AT ANY HOME DEPOT STORE.

Figure 20

Bulbs

Glass Shade

Glass Frame

Light Plate

1 2 ... 8 9 10 11 12 13 14 15 16 17

Comments to this Manuals

No comments