Hampton Bay 14938 Instruction Manual Page 1

Glacier Bay52 in Ceiling FanOwner’s Manual Glacier BayVentilador de Techo de 1,32 mManual del Propietario 178 128

7Repeat procedure with remaining blades.Screws with Rubber WashersScrewsBladesBlade HoldersWARNINGTO REDUCE THE RISK OF PERSONAL INJURY, DO NOT BEND T

8Blade BalancingFigure 17Check that all blade and blade holder screws are secure.Most fan wobble problems are caused when blade levels are unequal. Ch

9Attaching the Switch Housing AssemblyRemove the 1 of 3 screws from the mounting ring and loosen the other 2 screws. (Do not remove)While holding the

10Remove the 1 of 3 screws from the swith housing mounting plate and loosen the other 2 screws. (Do not remove)While holding the light plate under you

11Operating Your FanTurn on the power and check the operation of your fan. There are two pull chains available in your fan:1. 3-speed pull chain- it c

12WARNINGMAKE SURE THE POWER IS OFF AT THE ELECTRICAL PANEL BOX BEFORE YOU ATTEMPY ANY REPAIRS. REFER TO THE SECTION, “MAKING ELECTRICAL CONNECTIONS”.

13SpecificationsFAN SIZE SPEED VOLTS AMPS WATTS RPM CFM N.W. G.W. C.F.52” 1209.51 kgs(20.92 lbs)11.37 kgs(25.01 lbs)2.25’LOWMED.HIGH0.210.360.46113255

14The Hampton Bay warrants the fan motor to be free from defects in workmanship and material present at time of shipment from the factory for a period

Glacier Bay by Hampton Bay ®

52” Glacier BayCeiling Fan by Hampton BayDate PurchasedStore PurchasedUL Model No.Serial No.Vendor No.UPCThank you for purchasing our ceiling fan. Thi

Safety Rules – Read and Save These InstructionsTo reduce the risk of electric shock, insure electricity has been turned off at the circuit breaker or

2Unpacking Your FanUnpack your fan and check the contents. You should have the following items:Set of blades (5)Canopy assemblyStandard Ball/downrod a

3Installing Your FanFigures 1~3 are examples of different ways to mount the outlet box.If there isn't an existing UL listed mounting box, then re

4REMEMBER to turn off the power. Follow the steps below to hang your fan properly.Remove the canopy cover from the canopy by turning the cover counter

5WARNINGTHE TAB IN THE RING MUST REST IN THE GROOVE OF THE HANGER BALL AS FIGURE 12. FAILURE TO PROPERLY SEAT THE TAB IN THE GROOVE COULD CAUSE DAMAGE

6blue wire will be on the other side, and push carefully up into the outlet box.Connect the ground conductor of the 120V supply (this may be a bare wi