Hampton Bay 14938 Instruction Manual download pdf (Page 10)

7

Repeat procedure with remaining blades.

Screws with

Rubber Washers

Screws

Blades

Blade Holders

WARNING

TO REDUCE THE RISK OF PERSONAL INJURY,

DO NOT BEND THE BLADE HOLDERS WHILE

INSTALLING, BALANCING THE BLADES, OR

CLEANING THE FAN. DO NO INSERT FOREIGN

OBJECTS BETWEEN ROTATING FAN BLADES.

3.

Attach the fan blade to the blade holder using

the screws with rubber washers provided,

tighten screws securely. (Fig. 16)

Align the holes in the motor and the blade

holder, then secure with the screws

pre-installed on the blade holder, tighten

screws securely. (Fig. 16)

Attaching the Fan Blades

1.

2.

Figure 14

Outlet Box

Hanger

Bracket

Screw

Screw

Canopy

Canopy

Bottom Cover

Finishing the Fan

Installation

Tuck connections neatly into ceiling outlet

box.

Slide the canopy up to hanger bracket and

place the key hole on the canopy over the

screw on the hanger bracket, turn canopy until

it locks in place at the narrow section of the key

holes. (Fig. 14)

Align the circular hole on canopy with the

remaining hole on the hanger bracket, secure

by tightening the two set screws. Note: Adjust

the canopy screws as necessary until the

canopy and canopy cover are snug. (Fig. 14)

1.

2.

3.

WARNING

MAKE SURE THE TAB ON THE HANGING

BRACKET PROPERLY SITS IN THE GROOVE IN

THE HANGER BALL BEFORE ATTACHING THE

CANOPY TO THE BRACKET BY TURNING THE

HOUSING UNTIL IT DROPS INTO PLACE.

Figure 16

NOTE

MOTOR IS SHIPPED WITH RUBBER MOTOR

STOPS TO PREVENT MOVEMENT DURING

TRANSPORTATION. REMOVE MOTOR STOPS

PRIOR TO ATTACHING BLADE BRACKETS.

(FIG. 15)

Figure 15

Screws

Rubber packing mounts

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17

Comments to this Manuals

No comments