Hampton Bay 13087 Instruction Manual download pdf (Page 7)

5.

Making the Electrical

Connections

REMEMBER to disconnect the power. If

you feel you do not have enough electrical

wiring knowledge or experience, have your fan

installed by a licensed electrician.

Follow the steps below to connect the fan

to your household wiring. Use the wire

connecting nuts supplied with your fan. Se-

cure the connectors with electrical tape.

Make sure there are no loose strands or

connections (Figure 6).

1. Insert the receiver into the ceiling mounting

plate with the at side of the receiver facing

the ceiling.

2. Connect both green wires from the down-

rod and mounting plate to the bare copper

(Ground) from the outlet box

3. Connect the black wire (AC IN L) from

the receiver unit to the black wire from the

outlet box.

4. Connect the white wire (AC IN N) from

the receiver unit to the white wire from the

outlet box.

5. Connect the white wire (To Motor N) from

the receiver unit to the white wire from the

fan assembly.

6. Connect the black wire (To Motor L) from

the receiver unit to the black wire from the

fan assembly.

Installing Fan to

the Outlet Box

1. Pass the 120-volt supply wires through the

center hole in the ceiling mounting plate as

shown in Figure 5.

2. Install the ceiling mounting plate on the

outlet box by sliding the mounting plate

over the two screws provided with the

outlet box (Figure 5). If necessary, use

leveling washers (not included) between the

mounting plate and the outlet box. Note that

the at side of the mounting plate is toward

the outlet box (Figure 5).

3. Securely tighten the two mounting screws.

4. Carefully lift the assembly up to the ceiling

mounting plate. Make sure the tab on the

mounting plate socket is properly seated in

the groove in the hanger ball.

EACH WIRE NUT (WIRE CONNECTOR) SUP-

PLIED WITH THIS FAN IS DESIGNED TO ACCEPT

UP TO ONE 12 GAUGE HOUSE WIRE AND TWO

WIRES FROM THE FAN. IF YOU HAVE LARGER

THAN 12 GAUGE HOUSE WIRING OR MORE

THAN ONE HOUSE WIRE TO CONNECT TO THE

FAN WIRING, CONSULT AN ELECTRICIAN FOR

THE PROPER SIZE WIRE NUTS TO USE.

7. Connect the blue wire (For Light) from the

receiver unit to the blue wire from the fan.

After wires are connected, carefully tuck them

into the outlet box. Insert the receiver unit into

the mounting plate; make sure the black anten-

na wire sits on top of the receiver unit.

THE FREQUENCIES ON YOUR RECEIVER AND

TRANSMITTER HAVE BEEN PRESET AT THE

FACTORY. BEFORE INSTALLING THE RECEIV-

ER, MAKE SURE THE DIP SWITCHES ON THE

RECEIVER AND TRANSMITTER ARE SET TO

THE SAME FREQUENCY. THE DIP SWITCHES

ON THE TRANSMITTER ARE LOCATED INSIDE

THE BATTERY COMPARTMENT.

1 2 3 4 5 6 7 8 9 10 11 12 ... 28 29

Comments to this Manuals

No comments