Hampton Bay YG187-NI Instruction Manual download pdf (Page 13)

Blade Balancing

Figure 19

Check that all blade and blade arm screws are secure.

Most fan wobble problems are caused when blade levels are unequal.

Check this level by selecting a point on the ceiling above the tip of one of

the blades. Measure from a point on the center of each blade to the point

on the ceiling. Measure this distance as shown in Figure 19. Rotate the fan

until the next blade is positioned for measurement. Repeat for each blade.

Measurements deviation should be within 1/8˝. Run the fan for 10

Minutes.

Use the enclosed Blade Balancing Kit if the blade wobble is still

noticeable.

The following procedure should correct most fan wobble. Check after each

step.

Touching Ceiling

1 2 ... 8 9 10 11 12 13 14 15 16 17

No comments

Hampton Bay YG187-NI Instruction Manual Page 13