Hampton Bay YG187-NI Instruction Manual download pdf (Page 12)

Attaching the Fan Blades

Step 1. Attach blades to blade arms using three

screws with rubber washers. (Fig. 17) Start a

screw into the blade arm, do not tighten. Repeat

for the 2 remaining screws and washers.

Step 2. Tighten each screw securely starting with

the center screw. Make sure the blade is straight.

Repeat steps for the remaining blades.

Step 3. Fasten the blade assemblies to the motor

housing by lining up the slots of the blade arms

with the tabs on the motor housing, then tighten

the two screws and washers already installed in the

blade arms. (Fig. 18)

NOTE

MOTOR IS SHIPPED WITH RUBBER MOTOR

STOPS TO PREVENT MOVEMENT DURING

TRANSPORTATION. REMOVE MOTOR STOPS

PRIOR TO ATTACHING BLADE BRACKETS. (FIG.

16)

Figure 16

Figure 17

Blade

Figure 18

WARNING

TO REDUCE THE RISK OF PERSONAL INJURY,

DO NOT BEND THE BLADE ARMS WHILE

INSTALLING, BALANCING THE BLADES, OR

CLEANING THE FAN. DO NO INSERT FOREIGN

OBJECTS BETWEEN ROTATING FAN BLADES.

Blade Arm

Screws with

Rubber Washers

Rubber Packing

Mounts

Screws

Motor

Tab

Blade Arm

Slot

Screw

1 ... 11 12 13 14 15 16 17

No comments

Hampton Bay YG187-NI Instruction Manual Page 12