120V FLEXIBLE TRACK PENDENT ADAPTOR
Adapts direct wire or track pendants for use with 120V Flexible Track system.
For use with Hampton Bay EC series line flexible track. 60 Hz 120V
Installation Instructions:
IMPORTANT: Before installing, disconnect power by turning off the circuit breaker or by removing the fuse at the fuse box.
Step1:
1. Open the adaptor cover by removing the set screw.
2. Loosen the three set screws on the lower portion of the wiring terminal.
3. Determine the desired location of the pendant.
4. When the desired length is established, mark the pendant wire.
5. Cut the wire at the mark.
NOTE: If installing more than one pendant and the same height is desired for all pendants make sure the mark on all pendants are at the
same length before cutting.
6. The pendant wire has three (3) smaller wires running inside of it. Remove 1 ½” of the outer insulation exposing the three (3) smaller
wires inside.
CAUTION: Be careful not to cut or damage the insulation on the inside wires when removing the outer insulation.
STEP2:
1. Pull the pendant wire through the bottom hole in the pendant adapter, and then secure the strain relief to the pendant wire. (NOTE:
Do not fully tighten the strain relief set screw, but secure with only 2 or 3 rotations so that the pendant wire can still be moved as
needed.
2. Remove a 3/8 inch of the insulation on all three (3) of the smaller wires.
3. Twist the copper wire strands.
STEP 3:
1. Carefully identify and connect the 3 wires following the pendant wiring instructions included with the pendant.
NOTE: Please Read all instruction of the pendant head (sold separately), to identify polarity of the wires, then connect Live to Live, Neutral
to Neutral, Ground to Ground. If you have any doubt, please contact or consult a qualified electrician.
2. Tighten screws to secure the wire.
3. Slide the strain relief to a suitable position on the wire and tighten the screws.
4. Position the strain relief to its original position in the adaptor.
5. Close the adaptor cover, and tighten the set screw.
INSTALLING ADAPTER TO TRACK:
1. Make sure that the power is turned off.
2. Remove the retaining cap on the power connector.
3. Open the power connector cover and align the two slots of the track to the two tabs on the power connector.
4. Close the power connector cover and replace the retaining cap.
5. Restore the electrical power.
ADAPTADOR DE ACCESORIO COLGANTE PARA RIEL FLEXIBLE DE 120 V
Adapta accesorios colgantes para cable directo o riel para usar con sistemas de riel flexible de 120 V
Para usar con los sistemas de riel serie Hampton Bay de 60 Hz 120 V
Instrucciones de instalación:
IMPORTANTE: Antes de realizar la instalación, corte la alimentación eléctrica general con el interruptor principal o quitando los fusibles en la
caja de fusibles.
Paso 1:
1. Abra la cubierta del adaptador retirando el tornillo de fijación.
2. Afloje los tres tornillos de fijación de la porción inferior del terminal de cableado.
(28 pages)
(1 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals