Hampton Bay PG139HDS Use and Care Manual download pdf (Page 16)

Lighting Instructions

□ Turn the LP gas tank valve OFF. Push the control

knob in, turn OFF, and wait 5 minutes for any gas

to clear.

□ Turn the tank valve ON. Push the control knob in

and rotate to PUSH. Then push the igniter button

and control knob until the burner is ignited. If the

burner fails to remain lit or becomes extinguished,

repeat this step after 5 minutes of complete shutoff

period before relighting.

□ Once the burner has lit, continue to hold the control

knob in for 30 seconds, and then release.

□ Turn the control knob from LOW to HIGH to the

desired heat setting.

For complete shutdown:

□ Turn the knob to the “Push” position first, then push

and turn to the “Off” position for complete shut off.

□ Turn the LP gas tank valve OFF before removing

the LP gas tank.

□ If you are unable to ignite the heater using the

above instructions, insert a match through the hole

on the bottom of the burner diffuser to reach the

burner.

WARNING:

If at any time you are unable to light the burner and

smell gas, wait 5 minutes to allow gas to dissipate

before attempting to light the heater.

WARNING:

DO NOT touch or move the heater for at least 45

minutes after use. Allow emitter and dome to cool

before touching.

CAUTION:

Avoid inhaling fumes emitted from the heater’s first

use. Smoke and odor from the burning of oils used

in manufacturing will appear. Both smoke and odor

will dissipate after approximately 30 minutes. The

heater should NOT produce thick black smoke.

Fig.16

Igniter

push

HIGH

OFF

PILOT

LOW

Fig.15

PUSH

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 35 36

Comments to this Manuals

No comments

Hampton Bay PG139HDS Use and Care Manual Page 16

Comments to this Manuals

Related products and manuals for Space heaters Hampton Bay PG139HDS