Hampton Bay 34112 Installation Guide download pdf (Page 11)

Speed settings for warm or cool weather

depend on factors such as the room size,

ceiling height, number of fans, etc.

The Reverse switch is located on the top of

the motor housing. Slide the switch to the

Left for warm weather operation. Slide the

switch to the Right for cool weather

operation.

NOTE: Wait for fan to stop before changing

the setting of the slide switch.

Warm weather - (Forward) A downward air

flow creates a cooling effect as shown in

Figure 21. This allows you to set your air

conditioner on a higher setting without

affecting your comfort.

Cool weather - (Reverse) An upward airflow

moves warm air off the ceiling area as shown

in Figure 22. This allows you to set your

heating unit on a lower setting without

affecting your comfort.

Restore power to the ceiling fan and test

for proper operation.

1. "HI, MED, LOW" buttons:

These three buttons are used to set the fan

speed as follows:

LOW=Low speed MED= Medium speed

HI=High speed

2. "OFF" button:

This button turns the fan off.

3.The " " button turns the light ON or OFF

and also controls the brightness setting.

Press and release the button to turn the light

ON or OFF. Press and hold the button to set

the desired brightness. The light key has an

auto-resume, it will stay at the same

brightness as the last time it was turned off.

Figure 19

Installing the battery:

Install 12V MN21/A23 battery (not

included), to prevent damage to

transmitter, remove the battery if not used

for long periods.

Figure 20

Operating the Transmitter 11.

1 2 ... 6 7 8 9 10 11 12 13 14 15

Comments to this Manuals

No comments