Thank you for purchasing this Hampton Bay interior bath bar. This product has been
manufactured with the highest standards of safety and quality.
FEATURES:
1. Available in Chrome or White finishes.
2. Designed with 3 - 100 watt bulb sockets.
3. Compatible with any standard 120 volt incandescent dimmer switch.
4. Wall mountable only.
QUESTIONS, PROBLEMS, MISSING PARTS:
Before returning to your local Home Depot, please call our Customer Service Team at 1-
877-527-0313 or visit www.homedepot.com. Please reference SKU 644-212, UPC
008938102087 or SKU 546-870, UPC 008938355308.
GENERAL:
1. Be sure to read these installation instructions and review the diagrams thoroughly
before installing this light fixture.
2. All electrical connections must be in accordance with local codes and the National
Electrical Code. If you are unfamiliar with methods of installing electrical wiring,
secure the services of a qualified licensed electrician.
3. This fixture is intended to be mounted to a 4 square x 2-1/8 deep metal octagon
outlet box. The box must be directly supported by the building structure.
4. Before starting the installation, disconnect the power by turning off the circuit
breaker or by removing the appropriate fuse at the fuse box. Turning the power off
using the light switch is not sufficient to prevent electrical shock.
5. Keep your receipt and these Instructions for Proof of Purchase.
Note: The important safeguards and instructions appearing in this manual are not meant to
cover all possible conditions and situations that may occur. It must be understood that
common sense, caution and care are factors that cannot be built into any product. These
factors must be supplied by the person(s) caring for, installing and operating the fixture. If
at any time you are uncomfortable or are unsure of what to do, please contact a qualified
licensed electrician for further assistance.
TOOLS REQUIRED FOR ASSEMBLY & INSTALLATION (not included):
PARTS INCLUDED FOR ASSEMBLY (parts are not to scale):
x2 Screws x3 Wire Connectors x2 Tapped Screws x 2 anchors
INSTALLATION INSTRUCTIONS:
1. Turn off the power by either turning off the breaker at the electrical panel or by
removing the fuse from the fuse box.
2. If you are replacing an existing fixture, disconnect and remove the old fixture. Expose
the supply wiring from the outlet box.
3. Remove the back mounting plate (A) from the front cover (B). Set aside for
reassembly.
4. Fasten the back mounting plate (A) to the wall using the two anchors and tapped
screws supplied. Or fasten the back mounting plate (A) to the outlet box using the two
screws supplied with the outlet box. Your fixture is supplied with a back mounting
plate with two keyhole slots for attachment to the front cover (B). It will be necessary
to mark the location of the keyholes slots on the back mounting plate surface (A) and
Ladder Safety Gloves Flathead Phillips Electrical Wire A19 or G25
Goggles Screwdriver Screwdriver Tape Cutters bulb
2
(24 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals