Hampton Bay N2008 Installation Guide download pdf (Page 6)

Page 6

PARTS INCLUDED FOR INSTALLATION (parts are not to

scale):

INSTALLATION INSTRUCTIONS:

3 ea Wire Connectors (#16)

2 ea Mounting

Screws (#14)

1. Thread the Fixture Mounting Screws (#13) into the provided holes of the Mounting Plate (#15),

as shown. Thread the Hex Nuts (#12) onto the Fixture Mounting Screws (#13). Do not tighten

the Hex Nuts (#12) at this time.

2. Pull the power supply wires out of the Outlet Box, and attach the Mounting Plate (#15) to the

Outlet Box using the Mounting Screws (#14), as shown.

3. Attach the Black Supply Wire (A) to the Black Fixture Wire (A1) and the White Supply Wire

(B) to the White Fixture Wire (B1) using Wire Connectors (#16). Connect the Fixture Ground

Wire (C1) and the Supply Ground Wire (C) together using a Wire Connector (#16). Wrap all wire

connections with electrical tape for a more secure connection.

Note: Consult your local electrical code for approved grounding methods.

4. Carefully, tuck all the wires and wire connections into the Outlet Box. Place the Canopy (#10)

over the Outlet Box and onto the Fixture Mounting Screws (#13). Adjust the Fixture Mounting

Screws (#13) until they protrude out from the Canopy 1/4”. Remove the Canopy (#10) and secure

the position of the Fixture Mounting Screws (#13) by tightening the Hex Nut (#12) against the

Mounting Plate (#15). Place the Canopy (#10) back into the Fixture Mounting Screws (#13), and

secure it into place using the End Caps (#11) provided.

5. Installation is complete. Turn on power at the circuit breaker or fuse box. Turn the light switch

on to activate the fixture.

1 ea Mounting Plate (#15)

2 ea Fixture Mounting

Screws (#13)

2 ea Hex Nuts

(#12)

2 ea End Caps

(#11)

1 2 3 4 5 6 7 8

No comments

Hampton Bay N2008 Installation Guide Page 6