Hampton Bay 18927-000 Instruction Manual download pdf (Page 5)

MOC.YABNOTPMAH 5

Please contact 1-855-HD-HAMPTON for further assistance.

Installation

Install the mounting bracket (A) to the junction box

(not included) with two junction box screws (AA).

Installing the metal shade

Making the electrical connections

and securing the canopy assembly

Pull the additional wire from the bottom loop on the canopy

assembly (B).

Place the shade (D) onto the socket assembly (E), then secure

with the bottom loop on the canopy assembly (B).

Installing the bulb and diffuser

Pull the additional wire from the canopy assembly (B).

Lift up the canopy assembly (B) toward the ceiling.

Installing the rubber washer (H) and diffuser (F) over the threaded

tube onto the socket assembly (E), and then

secure with the

Install three 60 Watt, type A, incandescent light bulbs (not included)

into the socket.

DO NOT EXCEED THE RECOMMENDED WATTAGES.

Allow the mounting screws to extend through two canopy

holes. Secure the canopy assembly (B) to the mounting

bracket (A) by threading the two canopy nuts (C) to the

ends of the two mounting screws.

Make the connections to a 120V AC 60Hz circuit.

Attach the green or bare wire from the electrical supply to

the green or bare wire from the ﬁxture.

to the white (neutral) wire from the junction box, and the

the junction box. .

If a ground wire does not exist in the junction box, connect

the ﬁxture ground wire directly to the ground screw located

on mounting bracket (A).

Secure the wire connections using wire connectors (BB).

Wrap the wire connections with electrical tape for a more

secure connection.

Tuck all wires back into the junction box. No loose strands or

connections should be present.

Preparing the unit for installation

Carefully unpack and lay all parts on a clean, level surface.

Before starting the installation of this ﬁxture or removal

of a previous ﬁxture, disconnect the power by turning off

the circuit breaker or by removing the fuse at the fuse box.

NOTE: Pre -assembled mounting screws will be facing the oor

1 2 3 4 5 6 7 8 9 10 ... 13 14

Comments to this Manuals

No comments

Hampton Bay 18927-000 Instruction Manual Page 5

Comments to this Manuals

Related products and manuals for Unknown Hampton Bay 18927-000