Hampton Bay 15039 Installation Guide download pdf (Page 6)

Page 6

PARTS INCLUDED FOR INSTALLATION (parts are not to scale):

1 Cap Nut (#4) 1 Hex Nut (#7) 2 Outlet Box Screws (#8) 1 Nipple (#6)

1 Crossbar (#9) 3 Wire Connectors (#13) 1 Ground Screw (#10)

INSTALLATION INSTRUCTIONS:

1. Attach the Crossbar (#9) to the Outlet box(#12) with the two Outlet box Screws (#8)

as shown. The side of the Crossbar(#9) marked “GND” must face out.

. Th

read the Nipple (#6) part way into the center hole of the Crossbar(#9).

3. Connect the white wire from the fixture to the white wire from the Outlet Box (#12),

and the black wire from the fixture to the black wire from the Outlet Box (#12).

Cover the two wire connections using the two provided Wire Connectors (#13). Wrap

the two wire connections with electrical tape for a more secure connection. If your

outlet box has a ground wire (green or bare copper), connect fixture’s ground wire to

it using the wire connector (#13). Otherwise connect the copper ground from the fixture

to Ground screw (#10) on the Crossbar (#9). Note: If you have electrical questions,

consult your local electrical code for approved grounding methods.

4. Place the Fixture body (#3) over the Nipple(#6) so it protrudes through the center

hole. Screw the Cap Nut (#4) onto the end of the Nipple(#6) until fixture is secured

to the wall.

5. Install the proper light bulbs (not included) for your fixture. (DO NOT EXCEED

THE SPECIFIED WATTAGE!)

6. Installation is complete. Turn on the power at the circuit breaker or fuse box. Turn

the light switch on to activate the fixture.

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

No comments

Hampton Bay 15039 Installation Guide Page 6