Hampton Bay 51271 Installation Guide download pdf (Page 10)

CLOSE-TO-CEILING MOUNTING

1. Carefully unhook the fan from the mounting

plate and align the locking slots of the ceiling

canopy with the two screws in the mounting

plate. Push up to engage the slots and turn

clockwise to lock in place. Immediately

tighten the two mounting screws rmly.

2. Install the remaining two mounting screws

into the holes in the canopy and tighten

rmly.

3. Install the decorative canopy ring by

aligning the ring’s slots with the screws

in the canopy. Rotate the ring counter-

clockwise to lock in place.

4. You may now proceed to attaching the fan

blades.

8.

LOCKING SLOTS OF CEILING CANOPY ARE

PROVIDED ONLY AS AN AID TO MOUNTING.

DO NOT LEAVE FAN ASSEMBLY UNATTENDED

UNTIL ALL FOUR CANOPY SCREWS ARE

ENGAGED AND FIRMLY TIGHTENED.

Attaching the

Fan Blades

1. Attach the blade to blade bracket using the

screws as shown in gure 13. Please note

that the rubber washers are pre-attached

to the blade bracket. Start a screw into

the bracket. Repeat for the two remaining

screws.

2. Tighten each screw securely.

3. Fasten the blade/ blade bracket assembly to

the motor by inserting the alignment post

into the slot on the bottom of the motor and

tightening the blade bracket screws. Please

note that the blade bracket screws are pre-

installed into the blade bracket (Figure 14).

4. Repeat steps 1, 2 & 3 for the remaining

blades.

Slot

Alignment Post

Screws

Blade/Blade Bracket

Assembly

Screws

Blade

Rubber Washers

Blade Bracket

Figure 13

Figure 14

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments