Hampton Bay 34313 Installation Guide download pdf (Page 11)

9. Operating the Transmitter

9 Vol

t

Ba

tter

y

Figure 17

Installing the battery:

Install 9 volt battery (not included), to

prevent damage to transmitter, remove the

battery if not used for long periods. (Fig. 17)

Restore power to ceiling fan and test for

proper operation.

1. " LO, MED, HI" buttons:

These three buttons are used to set the fan

speed as follows:

LO= Low speed MED= Medium speed

HI= High speed

2. "FAN OFF" button:

This button turns the fan off.

3. The "LIGHT/DIMMER" button turns the

light ON or OFF and also controls the

brightness setting. Press and release the

button to turn the light ON or OFF. Press

and hold the button to set the desired

brightness. The light key has an auto-

resume, it will stay at the same brightness

as the last time it was turned off.

Speed settings for warm or cool weather

depend on factors such as the room size,

ceiling height, number of fans, etc.

The Reverse switch is located on top of the

motor assembly. Slide the switch to the Left

for warm weather operation. Slide the switch

to the Right for cool weather operation.

NOTE: Wait for fan to stop before changing

the setting of the slide switch.

Warm weather - (Forward) A downward air

flow creates a cooling effect as shown in

Figure 19. This allows you to set your air

conditioner on a higher setting without

affecting your comfort.

Cool weather - (Reverse) An upward airflow

moves warm air off the ceiling area as shown

in Figure 20. This allows you to set your

heating unit on a lower setting without

affecting your comfort.

Figure 18

LIGHT / DIMMER

LO

MED

HI

FAN OFF

1 2 ... 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments