Hampton Bay 34002 Installation Guide download pdf (Page 6)

Your fan is packed with the motor and Upper

Housing unassembled, proceed the following

steps for fan assembly:

Step1. Remove the two screws and rubber

washers from the top of the motor center band.

Place the upper housing over the motor center

band and secure it with the two screwsand

rubber washers previously removed.(Fig.5)

Step2. Engage the white wire connectors

from the motor and the bulb holder assembly

make sure the connection is secured Follow

the same procedure for the orange and black

wire connectors.(Fig.6)

Step3. Loosen the three screws (do not

remove) from the motor coupling.(Fig. 7)

Step4. Place the bulb holder assembly key

holes over the 3 screws previously loosened

from the motor coupling, turn the bulb holder

assembly until it locks in place at the narrow

section of the key holes. secure by tightening

the three screws previously loosened.(Fig.7)

Figure 5

Screw

Motor

center

band

Top motor

Upper housing

Figure 6

Wire

connectors

Screws

Figure 7

Motor

Motor

coupling

Bulb holder

assembly

Bulb holder

assembly

Motor

Rubber

washers

Assembling your fan 4.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments