Hampton Bay 14934 Instruction Manual download pdf (Page 8)

5

REMEMBER to turn off the power. Follow the

steps below to hang your fan properly.

Remove the metal washer from the fan motor

by removing the 4 outer and 3 inner CHROME

screws from the metal washer. For your safety,

please don’t remove black screws on top motor

housing. (Figure 8)

Remove the canopy cover from the canopy by

turning the cover counter clockwise. (Figure 9)

Remove the hanger bracket from the canopy by

removing the non-slotted screws from the

bottom of the hanger bracket and loosening the

other one a half turn from the screw head.

Next, turn the canopy counter clockwise to

removing the hanger bracket from the canopy.

(Figure 9)

Remove the clevis pin, cotter pin and set

screws from the top of the motor assembly.

(Figure 10)

Remove hanger ball from downrod assembly

by loosening set screw, removing the cross pin,

and sliding ball off rod. (Figure 11)

1.

2.

3.

4.

5.

Carefully feed motor wires up through the

downrod. Thread the rod into the coupling.

Next line up holes and replace cotter pin and

clevis pin. Tighten set screws. (Figure 12)

Slip coupling cover, canopy cover and canopy

onto downrod. Carefully reinstall hanger ball

onto rod being sure that cross pin is in correct

position, set screws are tighten and wires are not

twisted. (Figure 13)

6.

7.

WARNING

FAILURE TO PROPERLY INSTALL COTTER

PIN AS NOTED IN STEP 6 COULD RESULT IN

FAN LOOSENING AND POSSIBLY FALLING.

Option 2:

Downrod Mounting

Installation

Hanger

Bracket

Ceiling Canopy

Canopy Bottom

Cover

Figure 9

Figure 10

Set Screws

Clevis Pin

Cotter Pin

Figure 8

Metal Washer

Upper Motor Housing

Figure 11

Cross Pin

Hanger Ball

Downrod

Metal Washer

DO NOT Remove

the 3 Black Screws

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 16 17

Comments to this Manuals

No comments