Hampton Bay EC1290WH Use and Care Manual download pdf (Page 3)

ASSEMBLY INSTRUCTIONS (AS SHOWN IN DIAGRAM):

1. Make sure the main power to the circuit is OFF.

2. Install mounting bracket to existing outlet box with screws.

3. Pull wires through mounting bracket hole.

4. ELECTRICAL CONNECTIONS:

a. Connect the white wire(s) from the fixture to the white wire of the supply

circuit.

b. Connect the black wire(s) from the fixture to the black wire of the supply

circuit.

c. Connect the green colored (or bare copper) wire to the grounding conductor

of the supply circuit.

d. Use U.L. Listed wire connectors suitable for the size, type and number of

conductors. No loose strands or loose wires should be present.

e. Secure wire connectors with U.L. Listed electrical tape.

f. Carefully tuck connected wires back into the outlet box.

5. Place the canopy onto the mounting bracket making sure that the thread tube aligns

with the hole in the center of the canopy.

6. Secure the canopy by screwing the decorative nut onto the end of the thread tube.

RELAMPING THE BULB

1. Make sure that the power is turned off.

2. THE BULB IS HOT! Make sure that the bulb is cool before re-lamping the

fixture.

3. For first time installation. Remove the housing cap by turning it anti-clockwise.

4. Insert bulb into lamp housing, rotate bulb until it locks.

5. Replace the housing cap to lamp housing, by turning it clockwise.

6. Restore electricity and check the operation of your new lighting fixture.

CAUTION: Refer to the re-lamping label located near the lamp holder for

recommended maximum wattage. DO NOT exceed the recommended maximum

wattage.

ASSEMBLY DIAGRAM

1 2 3 4 5 6 7 8 ... 11 12

No comments

Hampton Bay EC1290WH Use and Care Manual Page 3