Hampton Bay EW0374CH Installation Guide download pdf (Page 2)

Assembly and Installation

1. Secure the mounting plate (5) to the outlet box (1) using the screws (6) provided.

2. Wiring Connections: Connect the white wire(s) from the fixture to the white wire of the supply circuit. Connect the black wire(s)

from the fixture to the black wire of the supply circuit. Connect the green or bare copper wire to the ground wire of the supply

circuit. Use UL/CSA listed wire connectors suitable for the size type, and number of conductors. No loose strands or loose wires

should be present. Secure wire connectors with UL/CSA listed electrical tape.

3. Place back plate (8) onto screw (7) through the holes on back plate (8) and then secure with finial (9). Adjust screw (7)

length as needed.

4. Place the shade (12) on the socket (13), Tighten the socket ring (11) to secure the shade (12) on to socket (13).

5. Screw the bulb (10) into the socket (13).

Re-lamping

1. Turn off the lamp at the switch and the main power supply.

2. Allow the fixture and bulb to cool before touching.

3. Remove the old bulb and insert a new bulb into the socket.

4. Restore the main power and turn on at the switch to check the operation of the bulb.

CAUTION: Refer to the re-lamping label near the lamp holder for recommended bulb type and

maximum wattage allowed (bulbs sold separately).

1. Junction Box

2. Wire Connector

3. Ground Wire

4. Ground Green Screw

5. Mounting Plate

6. Screw

7. Screw

8. Back plate

9. Finial

10. Bulb

11. Socket Ring

12. Shade

13. Socket

1 2

No comments

Hampton Bay EW0374CH Installation Guide Page 2