Hampton Bay 5LGZ1027-1 Instruction Manual download pdf (Page 4)

Assembly

Setting up the frame

□

Stand the frame (A) upright. Starting at the corners, with a partner

standing on the opposite side, grasp the two outer legs and

slightly lift the frame (A) off of the ground and step backward

stopping at full arm’s length.

Attaching the canopy

□ Unfold the canopy (B). Place the canopy (B) over the top of the

frame (A). Use the hook and loop straps to secure each corner of

the canopy (B) to the frame (A) .

Expanding the frame

□ Each partner should then grasp the bottom rails of the middle

frame section (cross beam) where it forms a diamond. Lift the

frame (A) slightly off the ground and slowly walk backward until

the frame (A) is fully extended.

Extending the corner rib

□ Engage the slider at each corner of the frame (A) by pushing up the

slider with one hand while holding down the top of the leg with the

other hand. Repeat this step at the remaining corners.

NOTE: The canopy and frame are shipped unattached to

avoid damage. First time set-up requires that the canopy be

attached to the frame. Once the canopy is permanently attached,

set up and take down are easily accomplished within seconds.

IMPORTANT: Please do not use too much force during

set-up.

WARNING:

backward to hard as this may result in the bending of cross

beams.

Grab here to open

1 2 3 4 5 6 7 8 9 10

No comments

Hampton Bay 5LGZ1027-1 Instruction Manual Page 4