Hampton Bay AC426-WCP Instruction Manual Page 1

Dawson54 in Ceiling FanOwner’s Manual DawsonVentilador de Techo de 1,37 mManual del Propietario 581 645

8Attaching the Fan BladesAttach blades to blade arm using the screws with fiber washers provided (Fig. 14). Start a screw into the blade arm, do not t

9Blade BalancingCheck that all blade and blade bracket screws are secure.Most fan wobble problems are caused when blade levels are unequal. Check this

10Installing the Light KitLossen the 3 screws from the light plate. (Do not remove)Raise and hold the light kit close to the light plate and proceed t

1111Installing the Battery:"HI, MED, LOW" buttons:These three buttons are used to set the fan speed as follows:LOW=Low speed, MED= Medium sp

12Speed settings for warm or cool weather depend on factors such as the room size, ceiling height, number of fans, etc.The Reverse switch is located o

13WARNINGMAKE SURE THE POWER IS OFF AT THE ELECTRICAL PANEL BOX BEFORE YOU ATTEMPY ANY REPAIRS. REFER TO THE SECTION, “MAKING ELECTRICAL CONNECTIONS”.

14SpecificationsFAN SIZE SPEED VOLTS AMPS WATTS RPM CFM N.W. G.W. C.F.54” 12015.73 kgs(34.61 lbs)17.90 kgs(39.38 lbs)3.25’LOWMED.HIGH0.360.520.5818457

15The Hampton Bay warrants the fan motor to be free from defects in workmanship and material present at time of shipment from the factory for a period

54” DawsonCeiling Fan by Hampton BayDate PurchasedStore PurchasedUL Model No.Serial No.Vendor No.UPCThank you for purchasing our ceiling fan. This pro

Safety Rules - Read and Save These Instructions1To reduce the risk of electric shock, insure electricity has been turned off at the circuit breaker or

2Unpacking Your FanUnpack your fan and check the contents. You should have the following items:ABCSet of blades (5)Canopy assemblyBall/downrod assembl

3Installing Your FanFigures 1~3 are examples of different ways to mount the outlet box.If there isn't an existing UL listed mounting box, then re

4REMEMBER to turn off the power. Follow the steps below to hang your fan properly.Hanging the FanWARNINGFAILURE TO PROPERLY INSTALL COTTER PIN AS NOTE

5WARNINGTHE TAB IN THE RING MUST REST IN THE GROOVE OF THE HANGER BALL AS FIGURE 8. FAILURE TO PROPERLY SEAT THE TAB IN THE GROOVE COULD CAUSE DAMAGE

6Making the Electrical ConnectionsWARNINGTO AVOID POSSIBLE ELECTRICAL SHOCK, BE SURE ELECTRICITY IS TURNED OFF AT THE MAIN FUSE BOX BEFORE WIRING.If y

7WARNINGMAKE SURE THE TAB ON THE HANGING BRACKET PROPERLY SITS IN THE GROOVE IN THE HANGER BALL BEFORE ATTACHING THE CANOPY TO THE BRACKET BY TURNING