Hampton Bay 26618 Installation Guide download pdf (Page 9)

7.

Figure 11

Figure 12

TO REDUCE THE RISK OF PERSONAL INJURY,

DO NOT BEND THE BLADE HOLDERS WHILE

INSTALLING, BALANCING THE BLADES, OR

CLEANING THE FAN. DO NOT INSERT FOREIGN

OBJECTS BETWEEN ROTATING BLADES.

Switch Cup /

Light Kit Asm.

Connector

Mounting

Screw (3)

Shade(3)

Knurled

(Provided)

Fan Switch

Light Switch

Switch Cup

Plate

Reversing

Switch

Screw(3)

Chain

Chain

Glass

Bulb (3)

Attaching the Light Kit

REMEMBER to disconnect the power.

1. Remove the three mounting screws on the

black switch cup plate below the motor.

2. Engage the connector of the switch cup/

light kit assembly with the motor connector

(Figure 12). The two connectors are keyed

and must be matted correctly before they

can be engaged. Make sure the connector

latch closes properly.

3. Position the switch cup/light kit assembly

on the black switch cup plate and align the

three holes in the switch cup/light kit assem-

bly with the holes in the plate. Re-install the

three mounting screws to secure the switch

cup/light kit assembly.

4. To install the glass shade, back the three

knurled screws out until the glass shade

neck slips into the glass holder (Figure

12). Then nger tighten the screws un-

til three screws touch the neck with ap-

proximate equal projection on the outside.

NOTE: Periodically check the tightness

of the knurled screws. Fan operation may

loosen these screws.

5. With the power off, insert the light bulbs

into the light sockets. Use 60w max bulbs

(provided).

If you need an extra switch cup

(or cover) for the non-light option,

please call 1-800-283-6513

(M-F 9:00am to 4:30pm EST).

in Figure 11. Rotate the fan until the next

blade is positioned for measurement. Repeat

for each blade. Measurement deviations

should be within 1/8”. Run the fan for 10

minutes.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 24 25

Comments to this Manuals

No comments