Hampton Bay 14923 Instruction Manual download pdf (Page 8)

5

Figure 10

Motor Wires

Ball/Downrod

Assembly

Ceiling Canopy

Canopy Ring

Pin in Locked

Position

Motor Collar

Coupling Cover

Tighten Screw

Firmly

Cotter Pin

Clip Pin

6. Slip coupling cover, canopy ring and canopy

onto downrod. Carefully reinstall hanger ball

onto rod being sure that cross pin is in correct

position, set screws are tighten and wires are not

twisted. (Figure 10)

Remove the decorative canopy bottom cover

from the canopy by turning the canopy bottom

cover counterclockwise (Figure 11).

Remove three of the six screws and lock

washers (every other one) from the collar of

top motor (Figure 12).

3.

4.

Route the wires exiting the top of the fan motor

through the canopy ring (make sure the slot

openings are on top). then proceed to place the

ceiling canopy and metal plate over the collar

at the top of the motor. (Figure 13)

Align the mounting holes with the holes in the

motor and fasten using the screws and lock

washers removed in step 4 (Fig. 13).

Tighten the mounting screws security.

5.

6.

7.

WARNING

FAILURE TO COMPLETELY TIGHTEN THE

THREE SCREWS IN STEP 7 COULD RESULT IN

FAN LOOSENING AND POSSIBLY FALLING.

Motor

Collar Screw and Lock Washer

(3 of 6 Places)

Figure 12

Figure 13

Option 2:

Close-to-Ceiling Mounting

Remove the canopy ring from the canopy.

(Figure 5)

Remove the mounting bracket from the canopy

by loosening the four screws on the top of the

canopy. Remove the two non-slotted screws

and loosen the slotted screws (Figure 6).

1.

2.

Canopy

Bottom

Cover

Remove

Figure 11

Collar

Ceiling

Canopy

Screw and

Lock Washer

(3 Places)

Canopy Ring

Metal plate

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Comments to this Manuals

No comments